Publicidad
ENGLISH
1. PARTS Y COMPONENTS
Fig.1
1.
Upper hinge
2.
Door handle
3.
Shelves
4.
Door gasket
5.
Display shelf
6.
Adjust foot
7.
Bottom hinge
2. BEFORE USE
Remove the product from the box and remove all packing material. Make sure that
all components are included, and if any are missing or not in good condition, contact
the official EVVO Technical Service immediately.
3. PRODUCT INSTALLATION
This device is designed to operate upright and should not be built-in.
Place the device on a flat, stable surface. To level the device, adjust its legs.
Do not install the device inside of a cabinet or any other place where you cannot see
the front part of the device.
There should be at least a 10-cm clearance between the device and its surroundings.
Do not place the device on a moist room or under direct sunlight or any other source
of heat. Inox models include handle and screws. To install the handle properly, follow
the below instructions.
Slowly remove the door's inner protection from the top part, you will see a whole.
Introduce the screw and push it to the end. The screw must be inserted completely
straight, in such way that it comes out the other side of the door.
Repeat these step on the inner part of the door and when both screws are installed in
place, fix the handle by tightening it with a screwdriver.
After plugging the device in, allow it to cool down for 2-3 hours before storing any
bottle inside it.
Note: Remember to keep some water inside the cabinet to keep the humidity.
16
EVVO VINOTECA VT15 COMPRESSOR
Publicidad
