Vaporfi ROCKET 3 Manual De Instrucciones página 3

ATOMIZER HEAD PRIMING:
When getting ready to use the provided 0.5ohm atomizer, it is important that you
prime the atomizer to avoid a burnt hit. This is an important cost saving measure.
Unscrew the base of the tank from the tank's body and remove the atomizer by
unscrewing it from the base. You will next take your e-liquid of choice and drop 3-5
drops into the center of the atomizer. To avoid flooding the atomizer, do not exceed
five drops. Once you have completed this task, screw the atomizer back into the base
and proceed to screw the base onto the body of the tank. You are now ready to fill
the tank with your e-liquid.
TANK FILL PROCESS:
After priming the atomizer, unscrew the top cap of your tank, take your liquid and
proceed to pour along the sidewalls of the center air pipe. After filling the tank,
screw the top cap back onto the body of the tank. Using short breaths, inhale from
the drip tip up to five times and allow the tank to sit for at least 10 minutes to give
the atomizer time to soak in your liquid.
Note: Do not overfill the tank; also to avoid leaking, do not allow any liquid to enter
the center air pipe.
3
www.vaporfi.com