General Safety Information
WARNING RISK OF FIRE, ELECTRIC SHOCK, OR INJURY .
•
ALWAYS unplug the machine before servicing .
•
DO NOT put any objects into openings .
•
ALWAYS keep hair, loose clothing, fingers, and all body parts away from openings and moving parts .
•
DO NOT turn the appliance on with the handle in the upright position . Ensure the handle is in operating position .
•
DO NOT leave the machine unattended while plugged in . Unplug the electrical cord when not in use or before servicing .
•
Use only as described in this manual . Use only manufacturer's recommended attachments .
•
DO NOT use with damaged cord or plug . If floor machine is not working as it should or has been dropped, damaged, left outdoors,
or dropped into water, return it to a service center before using .
•
DO NOT pull or carry by cord, use cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners .
•
DO NOT run floor machine over cord . Keep cord away from heated surfaces .
•
DO NOT use extension cords or outlets with inadequate current carrying capacity .
•
Verify if local voltage is 120V .
Electrical Instructions
WARNING
•
Improper connection of the equipment-grounding conductor can result in a risk of electric shock .
•
Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded .
•
DO NOT modify the plug provided with the appliance .
•
If plug will not fit the outlet, have a proper outlet installed by a qualified electrician .
•
This machine is for use on a nominal 120V circuit and has a grounding plug . Make sure the machine is connected to an outlet having
the same configuration as the plug . No adapter should be used with this machine .
Grounding
•
This floor machine shall be grounded while in use to protect the operator from electric shock .
•
The machine is provided with a three-conductor cord and a three-contact grounding type attachment plug to fit the proper
grounding type receptacle . The green (or green and yellow) conductor in the cord is the grounding wire . NEVER connect this wire
to anything other than the grounding pin of the attachment plug .
WWW.LAVEX.COM
User Manual
3