PREMIUM BALLON ACCESSORIES Cool Aire 4 Manual Del Usuario página 2

The Cool Aire® 4 Inflator was designed for mass inflation of latex balloons for balloon
drops, arches, etc., and incorporates Premium's 'Cool Aire Technology'. It has 4-nozzles
for 2-person use to maximize inflator operation and inflates 2 or 4-balloons at one time.
Two foot pedals are included for dual, hands-free inflation and the Cool Aire 4 unit has a
power "Booster- Switch" for its 3-speed motor, for fast, efficient inflation. The Cool Aire®
4 is available in 120-volt and 230-volt versions for Europe, UK and Australia. Pending
approvals include CE for Europe, CSA for Canada and UL for the USA.
1. Plug your Cool Aire
dry surface.
2. The Cool Aire
larger.
3. The unit comes with two foot pedals for hands-free inflation.
4. If only one person is operating the machine using only two of the four nozzles
for inflation, put the smallest latex reducer on the two unused inflation nozzles
to restrict the air flow. This will help increase the inflation pressure on the two
nozzles used for inflation.
5. Never block the air inlet vents. Do not block air outlet except for normal balloon
inflation usage.
6. Your Cool Aire® 4 includes 'Premium's Cool Aire Technology', which will keep the
machine from overheating under normal use, but it does come with internal thermal
protection. If somehow the machine overheats, the thermal protection will shut it off
to protect the motor from damage until it cools down. Turn the power switch off for
approximately 20-minutes to allow the machine to cool down or reset. To reduce
the reset time, unplug the machine, and move it to a cool, dry location with air
movement.
7. Although all motors are thoroughly tested at our manufacturing facility, heavy use
will cause further curing of the motor windings. This curing gives off a burning
smell and is typical for wound motors. This smell will quickly dissipate after a few
heavy uses.
Available models of Cool Aire
carrying the CSA mark, and 230-volt units for the European market, carrying the CE
mark. (Others may be available upon request.)
1.
Warning – To prevent fire or shock. Do Not expose unit to water or moisture.
2. Warning - Do Not place hands, face, or any other objects over the inflation nozzle
air discharge hole.
3. Warning – Do Not obstruct the inflation nozzle in any way or the air intake and
discharge vents located at the bottom of the inflator.
OPERATING INSTRUCTIONS
4 Inflator into wall socket and position machine on a flat, level,
®
4 was designed primarily to inflate latex balloons, 7" or 17.5cm and
®
4 include 120-volt units for the North American market,
®
SAFETY INSTRUCTIONS
English
1