Publicidad
Idiomas disponibles
Idiomas disponibles
▪
To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪
To remove: Press the battery release latch and pull the battery pack out at the same time.
9.5
Speed adjusting (Fig. 6)
The tool can be set at 6-speed adjustment positions. The "1" position indicates the lowest and
the "6" position indicates the highest speed, you can adjust different speed by turning the
speed control dial (4) from "1" to "6" position. The operator may have to vary the speed to
optimize working efficiency.
9.6
Application tips
9.6.1
Selecting the Application Tool/Accessory
Accessory (Fig 8)
A: 32 mm saw blade
B: 52 mm Scraping blade
C: Triangular sanding pad
D: Triangular sanding papers
9.6.2
Sawing
Use undamaged faultless saw blades only. Deformed, blunt saw blades or
saw blades that are otherwise damaged can break.
Plunge cuts may only be applied to soft materials, such as wood, gypsum
plaster boards, etc.!
Before sawing with saw blades in wood, particle board, building materials, etc., check these
for foreign objects such as nails, screws, or similar. If required, remove foreign objects or use
saw blades for metal.
9.6.3
Sanding
The removal rate and the sanding pattern are primarily determined by the choice of sanding
sheet, the pre-set oscillation rate and the applied pressure.
Only flawless sanding sheets achieve good sanding capacity and extend the service life of the
machine.
Pay attention to apply uniform sanding pressure; this increases the working life of the sanding
sheets.
Intensifying the sanding pressure does not lead to an increase of the sanding capacity, but to
increased wear of the machine and the sanding sheet.
For precise on-the-spot sanding of edges, corners and hard to reach areas, it is also possible
to work with the finger sanding pad.
Copyright © 2021 VARO
POWDP4060
P a g e
| 9
Material
Wooden materials, plastic, metal,
gypsum and other soft materials.
Suitable for the removal of paint
and carpet.
Sanding pad for 90x90x90 sized
sanding papers.
Sanding papers in different
grains:
•
60
•
80
EN
www.varo.com
Publicidad
