Publicidad
Idiomas disponibles
Idiomas disponibles
Note: 1. To the function mode you need, press Enter to confirm, press MODE about two seconds to quit.
2. The equipment can accept DMX signal whenever Auto or sound active mode, DMX is preferential.
3. Black out mode: Choose Yes, when no DMX, the unit goes to be Black out mode; Choose No, when no
DMX, the unit goes to be Sound mode.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX-output of the controller directly to the DMX-
input of the first fixture in a DMX chain. Connect the output of the first fixture with the input of the next fixture until
all fixtures are connected.
If you use a controller with 5-pin DMX connection, you will need to use a 5-pin to 3-pin adapter.
Caution at the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between
signal (-) and signal (+) into a 3-pin XLR connector and plug this into the DMX output of the last fixture in
the chain.
DMX CHANNELS
1 Channel Mode
3 Channel Mode
8
Display
Mode
ADDR
DMX address setting
CHND
Channel mode
SLND
Slave mode
Show mode
SHND
SOUN
Sound mode
SENE
Sound sense
BALA
White Balance
BLND
Black out mode
Led
LED mode
Display inversion
DISP
TEST
Test mode
TEMP
Temperature
Hour
Using time of light
Channel
Value
000-007
008-022
023-037
038-052
053-067
068-082
083-097
098-112
113-127
1
128-142
143-157
158-172
173-187
188-202
203-217
218-232
233-247
248-255
Channel
Value
1
0-255
2
0-255
3
0-255
Function
A001-A512
1CH/3CH/5CH/25CH/75CH
Master
One/Two Light Show (TLSH)
Four Light Show (FLSH)
Sound on/off
Sound sense 0-100
Red
000~255
LED mode, YES – NO
ON(led display on)
Display Inversion,Idsp-dspI
Self test
0 ~ 9999
Fixture hours,0 ~ 9999
Description
Blackout
Show 1
Show 2
Show 3
Show 4
Show 5
Show 6
Show 7
Show 8
Show 9
Show 10
Show 11
Show 12
Show 13
Show 14
Show 15
Show 16
Sound active running show 1 to 16
Description
Red
Green
Blue
Publicidad
