Publicidad
Idiomas disponibles
Idiomas disponibles
English
OPERATION
WARNING:
personal injury, turn unit off and remove the
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
Installing and Removing the Battery Pack
(Fig. G)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide it
into the handle until the battery pack is firmly seated in the
tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
6
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
On/Off Switch (Fig. H)
nOTE: This product is for dry pick-up only.
•
To switch the vac on, slide the On/Off switch
•
To switch the vac off, slide the On/Off switch
Run Time
When fully charged, the average effective usage times are
between 10-15 minutes.
It may take several chargings before these times can
be achieved.
MAINTENANCE
WARNING:
personal injury, turn unit off and remove the
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
Your CRAFTSMAN power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Cleaning
WARNING:
of all air vents with clean, dry air at least once a
week. To minimize the risk of eye injury, always
wear ANSI Z87.1 approved eye protection when
performing this procedure.
WARNING:
harsh chemicals for cleaning the non‑metallic parts
of the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
8
To reduce the risk of serious
5
into the tool handle, align the
1
1
To reduce the risk of serious
Blow dirt and dust out
Never use solvents or other
only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into
a liquid.
Dust Bowl (Fig. E)
iMPORTAnT: Maximum dust collection will only be
obtained with clean filters and an empty dust bowl. If dust
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying
Refer to Filter to remove the dust bowl
•
•
The dust bowl can be washed in warm soapy water.
Ensure that it is dry before re-attaching.
Motor Section (Fig. E)
iMPORTAnT: Never immerse the product in water.
A damp cloth and soapy water should be used to clean the
exterior of the motor section
is completely dry before re-use or storing.
Filter (Fig. E)
nOTE: The product performs better with a clean filter and
pre-filter.
•
Remove the pre-filter
dust off the filter.
•
Empty the dust from the dust bowl
if necessary.
forward.
•
Wash the pre-filter regularly using warm, soapy water.
back.
Ensure that it is completely dry before using again.
Accessories
WARNING:
those offered by CRAFTSMAN, have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service
center. If you need assistance in locating any accessory, please
contact CRAFTSMAN call 1‑888‑331‑4569.
On Board Storage (Fig. A)
The crevice
the motor housing.
VersaTrack™ (Fig. I)
WARNING:
personal injury, turn unit off and remove the
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
WARNING:
personal injury, do not use a damaged VersaTrack™
hang hook or VersaTrack™ Trackwall. A damaged
VersaTrack™ hang hook or VersaTrack™ Trackwall will
not support the weight of the tool.
10
. Always ensure the product
9
and shake or lightly brush loose
Since accessories, other than
7
slides into the on board storage
To reduce the risk of serious
To reduce the risk of serious
3
.
3
and wash
8
underneath
Publicidad
