Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Warnings and Instructions: Drills
WARNING:
1. Hold drill firmly with one hand on the grip and the other
hand on the side handle as shown in figure B.
2. When attaching accessories in the drill chuck, tighten
with all three holes to prevent slippage.
WARNING:
used) causing a twist. Always expect the stall. Grip the drill
firmly with both hands to control the twisting action and
prevent loss of control which could cause personal injury. If
a stall does occur, release the trigger immediately and
determine the reason for the stall before re-starting.
Assembly
WARNING:
To reduce the risk of injury, before assembly,
make sure that the tool is switched off and unplugged.
Attaching the side handle - (figure c)
If your drill is equipped with a side handle, it must be
installed properly to control the drill
• Turn the grip counterclockwise until you can slide the side
handle (9) onto the front of the tool as shown.
• Rotate the side handle into the desired position.
• Insert the depth stop (8) into the mounting hole as shown.
• Set the drilling depth as described under "Setting the
Drilling Depth."
• Tighten the side handle by turning the grip clockwise. Make
sure that the side handle is secure and does not slip.
Inserting a drill bit or other accessory
(figure D)
WARNING:
any other accessory) by gripping the front part of the chuck and turning the tool
on. Damage to the chuck and personal injury may occur when changing accessories.
WARNING:
bit may eject from tool causing possible personal injury.
• Open the chuck (6) by turning the collar counterclockwise (when viewed from the chuck end).
• Insert the accessory shaft into the chuck to about 3/4 in. (19 mm) depth, centered in the jaws.
• Tighten chuck collar by hand by turning the collar clockwise. Place chuck key (7) into
each of the three holes and securely tighten in a clockwise direction.
NoTe: Tighten chuck with all three holes to prevent slippage.
operating Instructions
WARNING:
and follow all safety warnings and instructions prior to using tool.
WARNING:
firmly with both hands to prevent loss of control which could cause personal injury.
WARNING:
gripping the front part of the chuck and turning the tool
on. Damage to the chuck and personal injury may occur
when changing accessories.
WARNING:
unplug drill from power supply before making any
adjustments or changing accessories.
WARNING:
work at its own pace. Do not overload.
Selecting the drilling mode (figure e)
• For drilling in masonry, set the drilling mode selector (5) to
the "hammer symbol" position.
• For drilling in other materials and for fastening, set the
drilling mode selector (5) to the "drill symbol" position.
Drill may stall (if overloaded or improperly
Do not attempt to tighten drill bits (or
Always ensure the bit is secure before starting the tool. A loose
To reduce the risk of serious personal injury, read, understand
It is important to support the work properly and to hold the drill
Do not attempt to tighten drill bits (or any other accessory) by
To reduce the risk of injury, always
To reduce the risk of injury, let the tool
5
B
c
d
e
Publicidad
