Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
• Unit will not start.
For assistance with your product, visit our website at www.bostitch.com. for a list of
service centers, or call the Bostitch Customer Care Center at (800) 262-2161.
CHUCK CAPACITY
R.P.M.
BITS, METAL DRILLING
WOOD, FLAT BORING
BITS, MASONRY DRILLING
MAINTeNANce
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
RePlAceMeNT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our service
website at www.bostitch.com. You can also order parts from your nearest Bostitch
Factory Service Center or Bostitch Authorized Warranty Service Center. Or, you can call
our Customer Care Center at (800) 262 2161.
SeRvIce AND RePAIRS
All quality tools will eventually require servicing and/or replacement of parts. For
information about Bostitch, its factory service centers or authorized warranty service
centers, visit our website at www.bostitch.com or call our Customer Care Center at
(800) 262 2161. All repairs made by our service centers are fully guaranteed against
defective material and workmanship. We cannot guarantee repairs made or attempted
by others.
You can also write to us for information at Bostitch, 701 E. Joppa Road, Towson,
Maryland 21286 - Attention: Product Service. Be sure to include all of the information
shown on the nameplate of your tool (model number, type, serial number, etc.).
AcceSSoRIeS
WARNING:
Since accessories, other than those offered by Bostitch have not
been tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only Bostitch recommended accessories should be used
with this product.
A complete line of accessories is available from your Bostitch Factory Service Center
or a Bostitch Authorized Warranty Service Center. Please visit our Web Site www.
bostitch.com for a catalog or for the name of your nearest supplier.
Troubleshooting
Possible cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
MAXIMUM RecoMMeNDeD cAPAcITIeS
1/2 in. (13 mm)
0–1100 / 0–3100
1/2 in. (13 mm) low speed
1-1/4 in. (32 mm)
optimum 3/16 in.–3/8 in. (5–10 mm)
maximum 3/4 in. (20 mm)
7
Possible Solution
• Plug tool into a working outlet.
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Bostitch
service center or authorized
servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a
Bostitch service center or
authorized servicer.)
• Have cord or switch replaced
at a Bostitch Service
Center or Authorized Servicer
Publicidad
