Publicidad
Idiomas disponibles
Idiomas disponibles
Check that the Torx screws [4f]
[4f]
Check that the lanyard hitch works correctly. Test the hitch under safe conditions on the ground. Check that the
the braking action can be controlled when a light pressure is exerted on the knot. The safe operation of the device
is related to the rope conditions of the GYRO ROPE [1] AND THE GYRO CORD lanyard [4a]: in the event these are
CHECKING AND MAINTENANCE - CARABINERS
A carabiner looses half of its resistance when the gate is open (see Tab.K): check the correct operation the lever
the same model.
PERIODIC INSPECTION
once every 12 months. This frequency should be increased if the equipment is used by multiple individuals or if
lifesheet. Keep all inspection and reference documentation for the entire life of the product. Do not remove or
tamper with the product labeling. Remove the product from service if its entire history is unknown and/or if the
records are illegible. I
service immediately:
• presence of cracks in metal components
•
the depth of which is estimated above 1 mm
• corrosion that severely alters the surface layer of the metal (does not disappear after being sanded lightly)
• slivers or excess wear on the surfaces which could damage the rope
• play or dislocation of the ball joints
•
• jamming of the connector's lever that cannot be resolved with normal lubrication
•
its expected lifetime. Attention: colors change can indicate chemical contamination. It must be replaced if there is
any doubt about its condition. Each product in the safety system can be damaged during a fall and must be always
inspected before use it again. Do not continue to use a product after a major fall because a damage may have
Fig. 4). If the O-ring [4g] is broken or missing.
55
[4f] using
O
Table A):
Publicidad
