Publicidad
Idiomas disponibles
Idiomas disponibles
Humidifier
Operation
Your new Sears humidifier is designed to
satisfy home humidity requirements
through the principle of evaporation of
water into the air.
After water is added to the humidifier, the
filter begins to soak up the water and will
become saturated in approximately 30
minutes. Air drawn in through the open-
ings in the lower housing passes through
the filter by means of a circulation fan. As
air passes through the filter, moisture is
absorbed into the air and then released
in the form of vapor. No water droplets
will enter the home. All evaporation
into
the air takes place in the humidifier,
which means that the residue left by
evaporating water is not passed into the
home, but remains in the filter.
This natural process of evaporation helps
eliminate the chance of white dust in the
humidified output air.
CAUTION:
Use only 42-14900 EPA
Registered
Baeteriostat
available
from SEARS Retait store. Under no
circumstances
should
you use water
treatment
products
designed
for
Rote beretor Ultrasonic
humidifiers.
Humidified
air is
then released
through
the top
Dry sir
enters
through
the
louvers
in
the housing
CAUTmON: To reduce the risk of
injury_ fire or damage to humidifier,
use only cleaners
specifically
recom-
mended for humidifiers. Never use
flammable,
combustible
or poisonous
materials
to s_ean your humidifier.
To
reduce the risk of saamds and damage
to humidifier,
never put hot water in
humidifier.
Assembly
Carefully remove the humidifier and al!
other contents from the carton.
There is a black strip that contains six
pads for the bottom of the humidifier.
Remove each pad and place one on
each of the six legs on the bottom of the
base as shown, by the solid dots.
Once installed return the humidifier to
it's original state and proceed to
"Location Instructions".
3
4
5
Publicidad
