Publicidad
Idiomas disponibles
Idiomas disponibles
POWER Amplifiers
Features and Specifications
Your new Jensen Power mobile mono power amplifier is the amplifier of
choice for the high demands of auto sound reproduction. With its deep-bass
reproduction and plenty of reserve power, low harmonic distortion and neutral
reproduction, the Power series of amplifiers takes Mobile Hi-Fi to new heights.
Like all Jensen products, when it comes to accurate sound reproduction the
Power series takes a back seat to no one. Jensen will bring your Hi-Fi
experience to new heights with the following features:
• MOSFET Output and Power Supply
·Optimized Class D Design Minimizes Distortion and Reduces Idle Current
• Easily Drives 1-0hm Loads
• Pass-Thru RCA's
• Variable Bass EQ 0 -12dB@ 45Hz
• 12dB
I
Octave Low Pass and High Pass filters
·Variable Input Level400mV- 4V
·Short Circuit, DC-offset and Thermal Overload Protection Circuitry
• Diagnostic LED's -Green: Power, Red: Standby
I
Fault
• Mono Subwoofer Amp
• Low Pass Filter 40 - 300 Hz, 12dB
I
octave
·Subsonic Filter 16-40Hz, 12dB
I
octave
·Remote Input Level Control (Remote Bass Control) with 5 Meter Interface
Cable
• Phase Switch 0 - 180 degrees
·Signal to Noise@ 120Hz:> 1 OOdB (Rated Power)
·Channel Separation Not Applicable
• THD+N @ 1 Watt: 0.02%, 125 Hz, 14.4VDC
Power Output
• RMS Power Output@ 2% THD+N, 1kHz, 14.4VDC
• 450 x 1 Watts, 4-0hm
• 725 x 1 Watts, 2-0hm
• 1000 x 1 Watts, 1-0hm
Specifications subject to change without notice.
2
Publicidad
