Publicidad
8
TBV BERLIN SERIES
11.
其他的重要信息
¼ '' TS
13.
14.
15.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
法律声明
12.
MUSIC Group
MIDAS, KLARK TEKNIK, LAB GRUPPEN,
LAKE, TANNOY, TURBOSOUND, TC ELECTRONIC,
TC HELICON, BEHRINGER, BUGERA
MUSIC Group IP Ltd.
© MUSIC Group IP Ltd. 2017
保修条款
music-group.com/warranty
16.
17.
2000
Welcome
Thank you for choosing a TURBOSOUND loudspeaker product for your application. If you would like further information about this or any other product, please visit our
website at turbosound.com.
Unpacking the Loudspeaker
DDA
After unpacking the unit, please check carefully for damage. If damage is found, please notify your supplier at once. You, the consignee, must instigate any claim.
Please retain all packaging in case of future return shipment.
System Requirements
The TBV123 is a 2-way loudspeaker that can be bi-amped using a Passive/Bi-amp selector switch. Bi-amp operation requires 2 amplifi er channels and 2 controller
channels, one for low frequencies and one for high frequencies. The input signal is divided between the low frequency and high frequency drivers in the controller,
and the individual amplifi ed signals are fed to the speaker inputs. Passive operation requires 1 amplifi er channel and 1 controller channel. When the selector switch is
set to Passive, the full range input signal is divided between the low frequency and high frequency drivers by internal passive crossovers.
Typically, 2-3 loudspeakers can be run from 2 amplifi er channels in bi-amp mode or 2-3 loudspeakers can be powered by 1 amplifi er channel in passive mode by
wiring the speakers in parallel.
The TBV123 loudspeaker also has selector switches that allow the output level of the high-frequency driver to be selected from 3 settings, depending on if the
loudspeaker is used on its own, or in an array with adjustments for long-throw or mid-throw.
The TBV118L subwoofer requires 1 amplifi er channel and 1 controller channel. The required fi lters and conditioning is applied to the signal in the controller and the
individual amplifi ed signals are fed to the speaker input.
Correct controller settings can be downloaded from turbosound.com, and are also available as presets for the LAKE LM series controllers and
LAB GRUPPEN DSP amplifi ers.
To avoid wasting amplifi er power, you should use heavy-duty speaker cable with a minimum wire size of 2.5 mm² (14 AWG), and preferably 4 mm² (12 AWG) for longer
runs or where total cabinet input impedance is less than 8 ohms. For extreme cable lengths, be aware of cable impedance and resistive losses.
Always observe the correct polarity.
Quick Start Guide
9
Publicidad
