Publicidad
STEP 12
IMPORTANT! THE BACK PANEL IS A STRUCTURAL PART OF THIS UNIT AND MUST BE INSTALLED
PROPERLY.
Carefully turn your unit over on its front side as shown. Attached the back panel to the area where the
fireplace insert will not go as shown nailing straight into the raw edges.
Assure that our unit is square.
Distance from corner to corner
must be equal as shown.
8
B
ameriwoodhome.com
8
(x20)
BACK
Raw Surface
PANEL
F
Notice: Now tighten screws (4)
in angle brackets (3) that were
left loose in step 6.
Flush bottom edge of the back
panel with the bottom edge of
bottom (F).
19
A
Publicidad
