Descargar Imprimir esta página

Sony BRAVIA KD-55X85K Guía De Configuración página 23

Televisor digital a color con pantalla de cristal líquido
Ocultar thumbs Ver también para BRAVIA KD-55X85K:

Publicidad

Idiomas disponibles

Idiomas disponibles

3
Fasten the screws into the marks
() on SCREW LINE () of WALL
MOUNT TEMPLATE as in the
illustration below.
228.5 mm
(9 in)
Screws
10 mm to
11 mm
(approx.
7/16 in)
4
Remove WALL MOUNT TEMPLATE.
5
Hang the Sound Bar on the
screws.
Align the holes of the rear of the
Sound Bar with the screws, then
hang the Sound Bar on the two
screws.
Note
When sticking WALL MOUNT TEMPLATE,
smooth it out fully.
20
US
228.5 mm
(9 in)
Marks ()
When the TV Remote
Control does not Work
When the Sound Bar obstructs the
remote control sensor of the TV, the TV
remote control may not work. In that
case, enable the IR repeater function of
the Sound Bar.
You can control the TV with the TV
remote control by sending the remote
signal from the rear of the Sound Bar.
Press and hold STANDARD for 5
seconds to set the function to on or
off.
IR repeater on
The HDMI and BLUETOOTH indicators flash.
IR repeater off
The Dolby ATMOS and DTS:X indicators flash.
Notes
• Be sure to check that the TV remote
control cannot control the TV, and then
set the IR repeater function to on. If it is
set to on when the remote control can
control the TV, appropriate operation
may not be obtained because of the
interference between the direct
command from the remote control and
the command via the Sound Bar.
• If the IR repeater function is set to on, this
function may not work depending on
your TV. Also, the remote controls of
other devices such as an air conditioner
may not work correctly. In this case,
change the installation position of the
Sound Bar or TV.

Publicidad

loading