ODA 010 Clipper Manual De Uso página 6

ENG
CHARGING THE APPLIANCE
Do not recharge the appliance if the ambient temperature is below 0º or above 40º.
• This appliance can be used on battery power or connected directly to the mains.
In the latter case, do not allow the battery to discharge completely.
• Recharge the device when you use it for the first time and every time the LED
starts flashing.
• Make sure the device is completely dry.
• To charge, the device must be switched off. Before charging, turn the power
switch to OFF..
• Fully charge the device at least once a year..
Charging can take place via an adapter connected directly to the device
or via the cradle.:
• Direct connection: connect the plug of the adapter D to the socket on the
bottom of the appliance C .
• Connection via cradle: place the device in the housing located in cradle G
and the adapter connector D to the socket at the back of cradle G.
• In both cases, connect the other end of the adapter to the mains socket..
• While charging, the LED will stay on and turn off when charging is
complete.
USE
CAUTION! Never use the appliance on wet hair.
Never use the appliance if the blades of heads A and E are damaged, in
bad condition or if the blade lock does not work properly.
• To switch the device on and off, press switch B.
• Wash the hair, dry it and brush it in the direction of growth, untangling
possible knots..
• After drying, do not use hairspray, mousse or gel.
• Start with the largest spacer comb and gradually go down in size until the
desired result is achieved.
• For best results, use the appliance in the opposite direction of hair growth.
• If a lot of hair accumulates on the spacer comb, remove the comb from the
appliance (see next section) and clean it by blowing or shaking to remove
the accumulated hair.
6