ODA 010 Clipper Manual De Uso página 8

ENG
Maintenance, replacement and adjustment of the head
The head components can be sharp. Take particular care during the
whole procedure.
Unscrew the screws of the head and remove the cutting comb and the blade (Fig. 4)
• Clean all the parts from any remaining hair.
• Reassemble by inserting the blade into the plastic feeder.
• Apply the comb and put the two screws back in.
• Before tightening the screws, check that the blade is aligned laterally to the comb
(Fig. 5–b/c) and align the comb so that between the front edge of the comb and
the front edge of the blade there is an approximate distance of 0.5 mm (Fig. 5-a).
• Tighten the screws.
• Recheck alignment of the cutting comb again.
• Repeat this procedure if alignment is poor or unsafe.
• Before using the appliance, check that it is working properly.
Incorrect alignment of the blade and the cutting comb can cause injury.
Ensure proper adjustment.
Lubrication
It is recommended to lubricate the blade unit daily or after every use.
To ensure that the cutting blade remains sharp, the cutting head must
be lubricated. It is recommended to regularly apply two to three drops of
lubricant I (fig. 1) directly on the blade (fig. 3).
If after a long period of use, and despite constant cleaning and oiling, the
cutting performance decreases, the head must be replaced.
If, after a long period of use and even after constant cleaning and greasing, the
machine cuts less than normal, the cutting head must be replaced. Contact with
your supplier.
DISPOSAL
The product packaging is made of recyclable materials. Separate the
parts according to their type and dispose of them in accordance with
applicable laws on the environmental protection.
Disposing of the battery and power adapter.
• Turn off the appliance.
• Remove the battery from its compartment.
Do not dispose of the batteries and/or power adapter with normal domestic
waste.
This appliance contains LI-PO (Lithium) type rechargeable batteries. The
end user is responsible for disposing of the batteries at a special waste
collection centre.
LI-PO
The batteries and power adapters are collected free of charge at collection points set
up by your local council or by any battery retailer. By doing this, you not only comply
with the law, but also help protect our environment.
8