Publicidad
Idiomas disponibles
Idiomas disponibles
RIGGING
Attention! The installation must be carried out by qualified service personal only. Improper installation can re-
sult in serious injuries and /or damage to property. Overhead rigging required extensive experience! Working
load limits should be respected, Certified installation materials should be used, the installed device should be
inspected regularly for safety.
OPERATION INSTRUCTIONS
Connect the fog machine only in an earthed mains outlet or extension cord.
HOW TO USE
1 • Unpack the fog machine (Do not connect yet the power cable).
2 • Fill the fluid tank .
3 • Connect the unit to mains outlet. Turn ON the mains switch. The heating
element is automatically switch ON. It will take about 4 minutes until the
working temperature is reached. Display will show « warming up».
4 • Once the LCD displays «Ready», you are ready to go.
5 • You can now use the unit in DMX mode, is manual mode, with wireless
remote controller or with wireless DMX signal transmission.
under "Volume Out". Press the Volume switch once more in order to stop the fog emission.
DMX CONTROL
Connect the machine directly to a DMX controller or a DMX loop with multiple DMX effects. The machine uses a 3-pin XLR
connector for DMX connection.
ADDRESS SETUP
Press the MODE button a number of times until Add appears on the display, with the UP / DOWN buttons the start address
may be set. The start address is defined as a first channel to which the machine will respond to. Check that there are no
overlapping channels used!
Press the Timer key to activate the timer function. The display shows the adjusted interval
and the device counts the seconds down to "0". After that, the fog emission is triggered
at the volume adjusted under "Timer Out". The duration depends on the settings adjusted
under "Duration Set". If you wish to deactivate the timer function, press the Timer key once
more.
MANUAL CONTROL (100% OUTPUT)
Press the Manual key for immediate triggering of the fog emission at 100 % volume. Let the
Manual key loose in order to stop the fog emission.
MANUAL CONTROL (LOCKED)
Press the Lock switch for immediate triggering of the fog emission at the volume adjusted
THE POWER CORD CAN ONLY
BE REPLACED BY AN ORIGINAL
UNPLUG THE MAINS LEAD
P.15
!
REPLACEMENT ONE.
BEFORE FILLING
THE FLUID TANK.
Publicidad
