Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION INSTRUCTIONS
Via the Menu key, you can adjust the desired settings. After pressing the menu, the display shows the following settings:
Man Vol Out xxx % Adjust the manual volume output within the range of 0% to 100% by means of the Up/Down keys
Interval Set xxxS
Adjust the interval between each fog emission within the range of 1 to 100S by means of the Up-/Down keys
Duration Set xxxS Adjust the duration of each fog emission within the range of 1 to 100S
Volume Out xxx%
Adjust the volume output during the timer function within the range of 0-100%
DMX512 #xxx
Adjust the DMX address for DMX control
Wind For Class xx NO FUNCTION for this smoke machine
Angle Set xx
NO FUNCTION for this smoke machine
LED Pro Set xx
Adjust the LED program within the range of 0 to 11
LED Spe xxx
Adjust the LED speed/strobe/fade of the LED program mode
LED Sync Set
Adjust the LED mode. Yes=LEDs work together with the smoke output, NO=LEDs are always on
Remote Out xxx% NO FUNCTION for this smoke machine
WIRELESS DMX
This ALGAM LIGHTING fixture is equipped with a DMX wireless transmission system. "WIRELESS DMX".
PAIRING YOUR DMX FIXTURE
1 • Connect the transmitter (Algam Lighting DMX-WT) to your DMX controller OUTPUT.
2 • Power up transmitter and the VULKAN PRO receiver.
3 • Press and hold 4 seconds on receiver button on your VULKAN PRO to reset the pairing until the
status LED becomes white.(this means that receiver is now ready to be paired).
4 • Press now on transmitter button to start pairing. Both receiver and transmitter will blink rapidly (transmitter in blue
color and receiver in green color). The pairing is processing. Once pairing is done, the transmitter status LED is now
fixed blue color and receiver status LED is fixed green color.
If Transmitter or receiver looses DMX signal, the status LED will blink slowly.
ADD A FIXTURE IN AN ACTIVE GROUP
1 • Press and hold 3 seconds on receiver button on your new fixture to reset the pairing until the status LED becomes
white.(this means that receiver is now ready to be paired).
2 • Press now on transmitter button to start pairing. Both receiver and transmitter will blink rapidly (transmitter in blue
color and receiver in green color). The pairing is processing. Once paring is done, the transmitter status LED is now
fixed blue color and receiver status LED is fixed green color. The other fixtures already paired in this group with this
transmitter remain paired of course.
SET UP A NEW GROUP
To set up a new group is very easy. You need one more transmitter of course. Keep the existing groups active , and start
the procedure above called « Pairing you DMX fixture».
NOTES
This DMX wireless system from Algam Lighting is not limited in number of groups and in number of fixtures connected in
a group.
P.16
Publicidad
