Publicidad
Idiomas disponibles
Idiomas disponibles
To Charge T222
1. Insert the micro USB output of the charging cable into the T222 & connect USB output to a wall
adapter (not included).
2. LED will flash RED/BLUE while charging & will remain lit BLUE once device is fully charged.
To charge electronic devices using the T222
1. For devices charged by micro USB: use charging cable provided. Insert USB output into T222 &
micro USB output into your electronic device.
2. For devices charged by 30pin or 8pin (or other): use the charging cable that came with your device.
Insert USB output into T222 & compatible output into your electronic device.
3. Blue LED light will remain lit while your device is being charged (blue LED will turn OFF once your
device is fully charged or if no more battery power remains)
4. To stop charging, disconnect the charging cable
CAUTION:
Risk of Fire and Burns, don't open, crush, disassemble and dispose of in fire. Accessible surfaces held or
touched for short periods only. Don't heat above 50 °C or Incinerate. Follow Manufacturer's Instructions
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Publicidad
