Dometic GROUP WAECO ECW-012VS Instrucciones De Montaje Y De Uso página 25

_ECW-012VS.book Seite 25 Montag, 15. Februar 2010 4:20 16
ECW-012VS
When selecting the installation location, observe the following instructions:
Do not operate the device
– In wet or damp environments
– In dusty environments
– In the vicinity of flammable materials
– In spaces where there is a danger of explosion
Do not expose the device to a heat source (such as direct sunlight or heat-
ing). Avoid additional heating of the device in this way.
Make sure the cables are the correct length and choose the installation
location near the battery supply.
Select a well-ventilated location for the device.
A ventilation system must be present for installations in small, enclosed
spaces. The clearance around the inverter must be at least 10 cm.
Make sure that the air intake underneath and on the back of the inverter
remains clear.
Select a mounting surface which is flat and sufficiently firm.
Fasten the inverter as follows:
Caution!
a
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Fasten the inverter with screws to a firm surface near the battery supply.
8 Connecting the inverter
Caution!
a
The inverter may only be connected by a qualified workshop.
The following information is intended for specialists who are famil-
iar with the guidelines and safety precautions to be applied.
Connecting the inverter
25