MoMi KENANI Manual De Usuario página 11

SEAT COVER AND HEADREST:
INSTALLATION:
Pull the seat cover over the frame and fasten the Velcro flaps on the back. To attach the headrest, the
Velcro flap should go through the loop located on the top of the seat cover.
REMOVAL:
To take off the seat cover simply detach the Velcro, and pull out the fabric of the metal frame.
CANOPY, MOSQUITO NET AND TOYS:
INSTALLATION:
To attach the toys to the canopy simply pull the Velcro flap through the two possible loops. Once the toys
are connected to the canopy fasten the clasps on the swing frame on both sides. The canopy part with
the elastic finish should go behind the seat, so that it overlaps the back of the headrest area of the swing.
The mosquito net can be quickly attached to the canopy with a zipper.
REMOVAL:
Pull out both clasps of the canopy to remove it.
NOTE: the seat cover has small fabric flaps which reveal the metal frame. Thanks to this, the canopy is more
securely attached to the frame. After the canopy net has been removed, the flaps should be closed to hide
access to the frame.
SAFETY BELT INSTRUCTION:
Place the baby into the bouncer and remember to adjust the seat belt on both sides equally. The buckle
of the safety belts is located in the crotch support restraint. It can be easily accessed by pulling on the
Velcro attachment.
NOTE: Make sure that the safety belt is fitted for the child.
WARNING: To ensure the safety of the child make sure that the safety belt is properly connected to the
buckle before using the bouncer.
MOTION LOCK:
Push the motion lock down to lock the bouncer in the starting position. Pull the motion lock up to unlock
the rocking motion.
WARNING: do not try to engage the lock while the bouncer is in motion.
POWER SUPPLY:
Plugin the adapter into the swing. The socket is located on the inside of the leg.
A. DC plug can be inserted into 100-240V ~ 50 / 60Hz AC power supply.
B. Adapter output parameters: voltage is 5V and current is 1A.
C. The adapter has a 2m long USB cable.
EN 11