Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT
SPECIFICATIONS
SERIAL NUMBER:
DATE OF PURCHASE:
GASOLINE CAPACITY/TYPE:
1.5 QUARTS
UNLEADED REGULAR
Z)ILTYPE (API-SF-SJ):
SAE 30 (ABOVE 32=F)
SAE 5W-30 (BELOW 32°F)
_)ILCAPACITY:
20 OZS.
;PARKPLUG(GAP: .045")
CHAMPION RJ19LM4
BLADE BOLTTORQUE:
35-40 FT. LBS.
, The model and serial numbers will be found on a decal attached to the rear of the
lawn mower housing. Record both sedal number and date of pumhase in the space
provided above.
LAWN MOWER
Alwaysobsewe safety ruleswhen performing
any maintenance.
TIRES
• Keaptiresfreeof gasoine, oil, orinsect
controlchemicalswhich can harm rubber.
• Avoid stumps, stones, deep nJts,sharp
objects and other hazards that may cause
tire damage.
BLADE CARE
For best results, mower blade must be
kept sharp. Replace bent or damaged
blades,
TO REMOVE BLADE
1. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
2. Turn lawn mower on its side. Make
sure air filter and carburetor are up.
3. Usa a wood block between blade and
mower housing to prevent blade from
turning when removing blade bolt.
NOTE: Protect your hands with gloves
and/or wrap blade with heavy cloth.
4. Remove blade bolt by turning counter-
clockwise.
5. Remove blade and attaching hard-
ware (bolt, lock washer and hardened
washer).
NOTE: Remove the blade adapter and
check the key inside hub of blade adapter.
The key must be in good condition to work
properly. Replace adapter if damaged.
TO REPLACE BLADE
1. Position the blade adapter on the
engine crankshaft.
Be sure key in
adapter and crankshaft keyway are
aligned.
2. Position blade on the blade adapter
aligning the two (2) holes in the blade
with the raised lugs on the adapter.
3. Be sure the trailing edge of blade
(opposite sharp edge) is up toward
the engine.
4. Install the blade bolt with the lock
washer and hardened washer into
blade adapter and crankshaft.
5. Use block of wood between blade and
lawn mower housing and tighten the
blade bolt, turning clockwise.
• The recommended tightening torque is
35-40 ft. Ibs.
IMPORTANT:
Blade bait is grade 8 heat
treated.
Bladeadapter _
Crankshaft
Key._.
_.1
"_
keyway
__j'
_
_C_rank
washer
Trailing edge Blade adapter
11
Publicidad
