Publicidad
Idiomas disponibles
Idiomas disponibles
TO SHARPEN BLADE
NOTE: We do not recommend
sharpening blade - but if you do, be sure
the blade is balanced.
Care should be taken to keep the blade
balanced. An unbalanced blade will
cause eventual damage to lawn mower or
engine.
• The blade can be sharpened with a file
or on a grinding wheel. Do not attempt
to sharpen while on the mower.
• To check blade balance, drive a nail
Into a beam or wall. Leave about one
inch of the straight nail exposed. Place
center hole of blade over the head of
the nail. If blade is balanced, it should
remain in a horizontal position, If either
end of the blade moves downward,
sharpen the heavy end until the blade
is balanced.
GRASS CATCHER
• The grass catcherrnay be _
with
water, but mustbe dry when used.
• Ch_:_ your grass catcher often for damage
or deterioratien. Through normal use it will
wear. If catcherneeds replacing,replace
onlywith a manufacturerapproved
replacementcatcher.Give the lawn mower
model numberwhen ordering.
ENGINE
LUBRICATION
Use only high quality detergent oil rated
with API service classification SF-SJ.
Select the oil's SAE viscositygrade
according to your expected operating
temperature.
L
T_TUR_
_IGE
ANT1CpAT_
BIE,_ Rll NE_
_
_i_
E
NOTE: Although muiti_viscosity oils
(5W30, 10W30 etc.) improve starting in
cold weather, these multi_viscosity oils
will result in increased oil consumption
when used above 32°R Check your
engine oil level more frequently to avoid
possible engine damage from running
low on oil
Change the oil after every 25 hours of
operation or at least once a year if the
lawn mower is not used for 25 hours in
one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Tighten oil plug
securely each time you check the oil
level
TO CHANGE ENGINE OIL
NOTE: Before tipping lawn mower to
drain oil, drain fuel tank by rUnning
engine until fuel tank is empty.
t.
Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
2. Remove engine oil cap; lay aside on a
clean surface.
3. Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to
remove any oil trepped inside of
engine.
4. Wipe off any spilled oil from lawn
mower or side of engine.
5. Fill engine with oil (see "ADD OIL" in
the Operation section of this manual).
6. Reconnect spark plug wire to spark
plug.
12
Publicidad
