sauermann Si-C320 Guía Rápida página 2

Quick Start Guide
English
These operating instructions describe how to connect a wireless module and a pressure
module into a Si-C320 transmitter.
Please refer to the operating instructions available at sauermanngroup.com for safe use of
the Si-C320 and detailed information.
Do not give these devices to a child.
1. Symbols used
For your safety and in order to avoid any damage of the device, please read carefully the
notes preceded by the following symbol:
2. Pressure module
While connecting the differential pressure module, the
transmitter must not be energized.
These instructions apply to the following pressure modules references:
Si-PRO-DP-50/Si-PRO-DP-250/Si-PRO-DP-1000, Si-PRO-DP-10000 and Si-PRO-ATMO.
Unscrew the plug screw of the drilling for the pres-
sure connections
Keep the pieces in which the pres-
Pieces in which the pressure
sure connections must be screwed.
connections must be screwed.
Connect the tubes to the corresponding pressure connections:
- pipe of the solenoid valve on the – pressure connection
- pipe of the "T" on the + pressure connection.
Once the module is connected, close the transmitter and refer to the full user manual to set
the differential pressure range.
(1) (2)
Put the two pressure connec-
tions and tighten them.
Place the pressure board by matching the holes for
spacers (1 on previous picture) and the red
connector (2 on previous picture).
Pressure board correctly inserted.
3. Wireless communication module
These instructions apply to the following wireless communication
module: Si-ACC-WLM
While connecting the wireless module, the transmitter must not be energized.
Hold the wireless communication module between
your fingers as shown on the picture and slide it
Wireless module communication
between the two holders.
holders
Once the module is connected, close the transmitter and refer to the full user manual to set
the wireless communication.
4. Relay module
These instructions apply to the following 4-relay module: Si-M4R
While connecting the 4-relay module, the transmitter must not be energized.
(2)
Place the relay module by
matching the holes for spacers (1
(1) on previous picture) and the red
connector (2 on previous pic-
ture).
The wireless communication module is corectly
inserted.
The relay module is properly installed and functional.