Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
1.
Lay bath seat upside down with upper legs pointing up on a flat, dry
surface.
2.
Attach lower leg by pushing in the locking button and sliding the lower
leg over the upper leg until it clicks into place. Repeat for other three
legs. Ensure all legs are locked before proceeding.
NOTE: Ensure seat support tube buttons protrude fully through channel
guide holes.
ADJUSTING LEG HEIGHT
Legs are already installed on the bath seat.
To adjust leg height:
1.
Press push button and slide leg extension up or down to desired
adjustment hole.
2.
Ensure push button fully protrudes through the leg adjustment holes of
the leg extension.
NOTE: An audible "click" will be heard.
3.
Repeat STEPS 1 and 2 for the other three legs.
NOTE: Ensure all four legs are adjusted to the same height and that all
height adjustment buttons protrude fully through the adjustment holes
before use.
Publicidad
