Publicidad
Idiomas disponibles
Idiomas disponibles
Continuous operation: Observe the cycles of
operation specified by the producer to ensure
proper engine work.
Using the lifting limit switch for common lifting
process switch-off.
To eliminate abnormal cable unreeling from the
drum, the hook and hook block must not touch the
floor.
Burden lifting with a haul-back block
The limit switch does not work when the cable reel
is operated with a haul-back block! Make sure the haul-
back block does not arrive to the cable reel nearer than
20 cm.
1.
Unscrew the haul-back block.
2.
Put cable to the haul-back block.
3.
Screw the haul-back block together again and tighten
the screws.
4.
Tie the lifted burden to the burden hook.
Emergency Action
Apply the first aid adequate to the injury and get qualified
medical assistance as quickly as possible. Protect the injured
person from more accidents and calm him/her down.
For the sake of eventual accident, in accordance with DIN
13164, a workplace has to be fitted with a first-aid kit. It is
essential to replace any used material in the first-aid kit
immediately after it has been used. If you seek help, state
the following pieces of information:
1. Accident site
2. Accident type
3. Number of injured persons
4. Injury type(s)
Handling requirements
The operating staff must carefully read the Operating
Instructions before using the appliance.
Qualification
Apart from the detailed instruction by a professional no
special qualification is necessary for using the appliance.
Minimum age
Only persons over 16 years of age can work with the
appliance. An exception includes youngsters if they work
within their professional education the purpose of which is to
obtain knowledge supervised by a trainer.
Training
Using the appliance only requires corresponding training by a
professional or following of the Operating Instructions. No
special training is necessary.
Technical data
Connector
Engine power
Max. lifting power with haul-back block
Max. lifting power without haul-back block
Max. lifting height at 300 kg
Max. lifting height at 600 kg
Cable diameter
Cable length
Protection type
Weight
Transport and storing
Assembly and preparation
Installation
When unpacking your cable reel, make sure the supply
includes all parts and check the state of the reel and
accessories if not faulty. To ensure guarantee validity,
any claim needs to be reported immediately after your
product is supplied.
Please read thoroughly the Operating Instructions
supplied with the cable reel (this manual) and proceed
exactly according to the specified information when
installing the cable reel.
The structural part the cable reel is to be fixed to must
be able to bear at least the double value of the expected
burden (consultation with an expert recommended).
The cable reel is especially mounted to a steel tubular
bail arm. The used steel tube must have a diameter of
43 mm and its wall must be min. 3 mm thick.
The bail arm must be firmly anchored in the wall.
Anchoring must be stable to stand up to generated
forces.
Make sure the appliance is always fixed horizontally and
never awry.
If a haul-back block is used hang the burden hook (d) to
the hook holder (j) and bracket (o).
Putting the electric cable reel into operation
Step 1
Make sure the system voltage corresponds to the voltage on
the type label of the cable reel.
Step 2
Check the steel cable and all safety devices of the cable reel.
Step 3
Check whether the cable reel is installed properly and is able
to hold the max. lifted burden.
Step 4
Secure the burden against turnover and swinging and check
the supporting members.
Step 5
Lift the burden vertically and control it.
Electric cable reel is now ready for operation!
Residual risks and protective measures
Electric residual risks:
Threat
Direct
electric
contact
Indirect
230 Volt
electric
1050 W
contact
600 kg
300 kg
Other risks:
11 m
Threat
5,5 m
4,5 mm
Thrown-away
12 m
items or
spraying
IP 54 B
liquids
18 kg
15
15
When storing, it is necessary that the appliance is
put to a dry place, inaccessible to children and
unauthorised persons. Clean the appliance
thoroughly before longer putting out of operation.
Description
Protective measure(s)
Electric shock
RCD
Electric shock
RCD
through
medium
Description
Protective measure(s)
Oil can squirt
Always wear gloves and
from the
protective glasses.
electric cable
reel and cause
serious injuries.
Publicidad
