Jöllenbeck Powerstixx 5.1 Manual De Instrucciones página 13

4. How to fit or change batteries:
1. Using a screwdriver, remove the screw on the back of the remote
control (point 1 of diagram).
2. Before you remove the battery compartment, lay the remote control
on a suitable surface with function buttons pointing upwards
(point 2 of diagram). Pull out the battery compartment at the bottom
end of the remote control (point 3 of diagram). If there are no
batteries in the remote control, note that the spring of the contact
plate inside the battery compartment points downwards.
3. Remove old batteries and insert new batteries in the battery
compartment as indicated by the markings (see point 3 of diagram).
4. Fit the battery compartment into the remote control. Make sure
the + and - markings and the function buttons of the remote control
all point upwards (see right-hand diagrams)!
5. Replace the screw and fasten the battery compartment.
Notes about batteries:
• Keep batteries out of reach of children.
• Do not mix old and new batteries, or batteries of different types.
Follow manufacturer's instructions on battery use.
• Remove old, weak or worn-out batteries promptly.
• Always recycle or dispose of used batteries in accordance with local
regulations.
5. Troubleshooting
The system is correctly connected but the LED on the front of the
subwoofer does not light when switching on.
Make sure you have moved the switch on the back of the subwoofer to
ON.
13
D
GB
F
E
I
Fig. 3