SEA FLEX UNI PG Manual Del Usuario página 8

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
- If a code which is already inside the memory of the receiver is programmed, it will be deleted (4 flashes). In the
programming phase be careful to send only one impulse with the transmitter.
Radiocontrol deleting
- By pushing P1 button, select the channel where the radiocontrol has been memorized (CH1 or CH2 led
switched on).
- Push the button which must be deleted on the radiocontrol.
- The led will flash four times to confirm the deleting.
- Push P1 or wait 10 seconds to exit from the deleting programming (leds switched off).
P1
Once
Deleting of the whole memory - (Fig.4)
- Press repeatedly P1 until all LEDs light up.
- Push P1 button and keep it pushed for three seconds.
- All leds will start to flash (DELETING).
- Keep pushed P1 until the leds remain lit (about 10 seconds). Release P1.
Memory managing and copying
It is possible to backup, delete and manage codes inside the memory through the OPEN PLUS system (only if
configured on PLUS version).
For versions with fixed code it is anyway possible with an OPEN PLUS system to transfer data from a RX to
another but without being able to manage them.
WIth the RF UNI MODULE It is possible to copy the TX copying the MEM with the device MEM CLONE.
Installation
Fixing with screws
8
67410696
®
- (Fig.3)
LED CH1
P1
3 times
RF UNI PG (Nouveau modèle)
Programmation
s e
avec OPEN
r a i
l
CNR
Il est possible de stocker
jusqu'à 800 rolling code ou code
fixe.
Remarque: MEMO amovible
pour copie de sauvegarder
avec MEM CLONE.
English
P1
Twice
Fig.3
LED CH1
LED CH2
RF UNI PG (Vieux modèle)
CN4
Connecteur pour la
programmation avec Open Plus
Il est possible de stocker
800 TX en rolling code et
100 TX en code fixe.
Rev. 04 - 02/2016
LED CH2
Fig.4
RF UNI
Il est possible de
stocker 16 TX
(Rolling Code
ou code fixe)
Avec MEMO devient RF
UNI PG (Voir RF UNI
PG Nouveau modèle)
Remarque importante: Lorsque
vous ajoutez le MEMO l'insertion
CNR
doit être fait avec armoire éteinte et,
après avoir restauré le courant, vous
devez attendre 10 s pour permettre le
transfert de données en mémoire.
CNR