Publicidad
Idiomas disponibles
Idiomas disponibles
A. PARTS DIAGRAM
1. Front Guard
2. Blade Cap
3. Blade
4. Guard Lock Nut
5. Clip
6. Rear Guard
7. Motor Shaft
8. Shaft Spin
9. Motor
10. Motor Rear Housing
11. Swivel Joint
12. Power Cord
13. Main Body
14. Bottom Plate
15. Rubber Foot
16. Pull cord for speed
17.Pull cord for oscillating
18. Rotary switch
19. Motor front Housing
B. ASSEMBLING INSTRUCTIONS
1.
Unscrew the Blade Cap by turning clockwise & Guard Lock Nut by turning counter clockwise.
2.
Mount the Reat Guard to the Motor by matching the 3 holes on the Rear Guard to the 3 round pin son the
motor Front housing.
3.
Secure the Rear Guard to motor housing with Guard Lock Nut.
4.
Insert the Blade onto Motor Shaft by matching slots in the Blade with pin in shaft and tighten the Blade with
Blade Cap by turning counter clockwise.
5.
Test blade by rotating with your hand. Make sure there is no friction with Guard Lock Nut. Blade should rotate
freely otherwise repeat steps again from step 1.
6.
Mount Front Guard onto Rear Guard by inserting hook of Front Guard over Rear Guard & secure with Clips
on Front Guard.
5
WALL FAN 16"
TVW016110MD
Publicidad
