ASSEMBLY INSTRUCTIONS
ES
UNPACKING THE BOX
After opening the carton, remove all parts and compare them with the
following list of included components:
PT
1. High pressure hose hook.
2. Handle
3. Gun Stand
EN
4. Switch
5. Triangular brush
FR
6. Detergent container
7. Outdoor floor cleaner
8. High pressure hose
9. Cleaning needle
10. Water inlet connector
11. Nozzle
12. Gun
13. Lance extension
Due to transport and packaging, some of the accessories may be
delivered disassembled. Please follow the assembly instructions.
ASSEMBLY
STEP 1
Install the gun bracket (3) by tightening it firmly to the main body as
shown in the figure.
Instruction manual
STEP 2
Attach the hook to the handle as shown, then tighten the screw with a
screwdriver. Screw the washer handle firmly to the main body as shown.
The screws are included with the main body, please check them and
leave them handy when unpacking.
STEP 3
Insert the lance extension (13) into the gun. Push and twist the
extension rod clockwise onto the gun (12) until it is hand tight to lock it
in place. When the parts are properly joined, the two components cannot
be separated by pulling them apart. All accessories must be inserted
into the gun for proper use.
B, Align the lug on the top of the nozzle (11) with the lug insert on the top
of the lance extension (13). Push the adjustable fan nozzle onto the end
of the lance. A click will be heard when it clicks into place.
STEP 4
Connect the high pressure hose (8) to the water outlet of the pressure
20
ref. 08472