Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: INJECTION RISK! The unit will start spraying
when the trigger is pulled. When the unit is turned off
ES
after use, there is still high pressure inside the hose and
unit. Point the gun in a safe direction and discharge excess
pressure.Never direct the high pressure water jet at people
or animals.
PT
AUTOMATIC ON/OFF
EN
FR
The pressure washer is equipped with an automatic on/off switch. The
pressure washer will only operate when the power switch is in the ON
position and the gun trigger is pulled. When you release the trigger to
stop spraying water through the gun, the pressure washer motor will
automatically shut off. Simply pull the trigger again to continue using
the cleaner. To stop using the pressure washer, release the trigger and
switch the unit to the OFF position. The unit should be completely shut
off when not in use or unattended.
PURGING THE GUN
It is very important to purge the gun before using the pressure washer.
Refer to the "Assembly Instructions" to assemble the pressure washer.
To purge the gun, simply connect the garden hose to the pressure washer
and pull the trigger before turning on the power supply. This allows air
trapped inside the pressure washer and gun to be removed before using
the unit. Continue to squeeze the trigger for approximately one minute
to allow excess air to escape from the unit. During this procedure, water
will flow through the gun at low pressure. For additional bleeding tips,
refer to the section titled "Operating Instructions".
GUN SAFETY LOCK
This pressure washer is equipped with a safety lock on the gun trigger.
When the pressure washer is not in use, use the safety lock to prevent
accidental activation of the high pressure jet.
Instruction manual
ADJUSTABLE SPRAY NOZZLE
The adjustable nozzle will allow you to use a variety of spray patterns,
from a full fan spray (diagram 1) to a straight stream spray (diagram 2).
When using the pressure washer to clean wooden decking, cladding,
vehicles etc., always start by using the fan spray and start spraying
from a minimum distance of 95cm to avoid damaging the surface of the
material you are cleaning. Always start spraying in a test area clear of
people and objects.
UNBLOCK NOZZLE
When the nozzle is clogged, it will cause the pump to build up pressure
and may cause the unit to speed up; you can clean the nozzle by
inserting the needle into the tip to remove debris.
For the adjustable nozzle, you can lubricate the nozzle collar (from high
pressure to low pressure) by using non-water soluble grease regularly.
USE OF DETERGENTS
22
WARNING: High pressure jets can be dangerous if used
incorrectly. The jet must not be directed at people, low
voltage electrical equipment or the appliance itself.
The pressure washer will dispense detergent at low
pressure. Use the adjustable spray nozzle to rinse and
clean.
Biodegradable detergents are specifically formulated to
protect the environment and your pressure washer. These
detergents will not clog the filter and will protect the
internal parts of the pressure washer for longer life.
ref. 08472
Publicidad
