Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Bevel Adjustment
The bevel adjustment feature allows you to make bevel cuts up to 45º.
Continuous Rim Diamond Wheel
The continuous rim diamond wheel provided with this saw is for wet cutting only. Dry cutting is
possible with the use of an optional cutting wheel marked as usable for dry cutting (not
included). This tile saw will accept either a 4" or a 4-3/8"(111 mm) continuous rim cutting
wheel.
Depth Adjustment
Change the depth of cut from 0 to 1-5/32 in. using the depth adjustment knob.
Ergonomic Design
The design provides comfort when operating in different positions and at different angles.
GFCI Plug
The saw is equipped with a GFCI plug to guard against the hazards of ground fault currents.
This plug does not protect against short circuits,overloads, or shocks.
LOCK-OFF Button
To prevent the switch trigger from being accidentally pulled, a lock-off button is provided.
Water Supply Kit
For wet tile cutting,install the water supply kit and connect to an appropriate water supply.
OPERATING INSTRUCTIONS
1. Attaching Water Supply Kit (Fig 4)
The water supply must come from a fresh water main. NEVER turn the water supply on high.
The water supply valve provides a convenient on/off control lever for starting and stopping the
water flow onto the cutting wheel.
• Unplug the saw.
• Attach the water supply kit to the saw as
shown using the screw provided. Tighten
securely.
• With the faucet turned completely off, attach
the faucet adaptor to a garden hose or
outdoor faucet.
• Once the cutting wheel is installed, the tile
saw is ready to be used.
NOTE: The tool is rated for a maximum water
pressure of 60psi.
NOTE: For dry cutting, it is not necessary to
install the water supply kit.
4
O
P
1 - Open position
2 - Closed position
15
2
1
N
Publicidad
