Haier AS25S2SF1FA-WH Manual De Operación página 7

Operation
Clock set
QUIET
HEALTH
MODE I FEEL
AIRFLOW
HEALTH SLEEP TURBO
SELF EXTRA
CLEAN
ECOSENSOR FUNCTION
CONFIRM
TIME TIME
ON OFF
CANCEL
LOCK LIGHT RESET
Attention:
The distance between the signal transmission head and the receiv-
er hole should be within 7m without any obstacle as well. When
electronic-started type fluorescent lamp or change-over wireless
telephone is installed in room, the receiver is apt to be disturbed in
receiving the signals, so the distance to the indoor unit should be
shorter. Full display or unclear display during operation indicates
the batteries have been used up. Please change batteries. If the
remote controller can't run normally during operation, please re-
move the batteries and reload several minutes later.
NOTE:
Remove the batteries in case unit won't be in usage for a long
period.
1.
Load the battery or press
the"RESET" button
RESET
2.
Press " " or "
set correct time
Each press will increase or
decrease 1min. If the button is
kept pressed, time will change
quickly.
3.
After time setting is confirmed,
press "confirm" button,while clock
starts working
CONFIRM
CANCEL
LOCK/LIGHT/RESET/
EXTRA FUNCTION
" to
QUIET
HEALTH
MODE I FEEL
AIRFLOW
HEALTH SLEEP TURBO
SELF EXTRA
CLEAN FUNCTION
ECOSENSOR
TIME TIME CONFIRM
ON
OFF
CANCEL
LOCK LIGHT RESET
1.
LOCK Button
LOCK
Used to lock buttons and LCD display.
2.
LIGHT Button
LIGHT
Turn on and off the indoor display. To
display only set temperature, press
LIGHT button 10 times within 5 sec-
onds. The indoor unit will beep 3 times
when successful. To return to ambient
temperature display, press LIGHT 10
times within 5 seconds again. Default
of the indoor unit display is ambient
temperature. The set temperature will
only display for a few seconds after
adjusting it with the remote.
3.
RESET Button
RESET
If the remote control is not functioning
properly, press this button to reset the
remote.
4.
EXTRA FUNCTION Button
EXTRA
FUNCTION
Function:A-B yard→10ºC heating (Only
in heating mode) →ºF/ºC transform
2