Sylvania CR130SL8 Manual Del Usuario página 8

[] Basic Connection
Thissection describes h owto c0nnect t he unit toan antenna,cable/satellite box, e tc.
Note:
• Besure your an tenna or other device is connected properly before plugging in the power cord.
[Antenna Cable Connection]
When connecting the unit to an antenna or cable TV company (without cable/satellite box)
Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.
e.g.)
VH F/_
antenna _ "
RF coaxial cable
rear of this unit
cableTV
company
_Once connections are completed, turn on the unit and begin initial setup.
Channel scanning is necessary for the unit to memorize all available channels in your area.
(Refer to"Initial Setup"on page 10.)
Note:
• Foryour safety and to avoid damage to device, please unplug the RFcoaxial cable from the an tenna input jack before moving the unit.
• If you use an antenna to receive analog TV,it should also work for DTV reception. Outdoor or attic antennas will be more effective than
settop versions.
• To easily switch your reception source between antenna and cable, install an antenna selector.
• fyou connect to the cable system directly, contact the CATVinstaller.
[Connection to Cable Box or Satellite Box]
Connect the RF coaxial cable on your home outlet to the input jack of the cable/satellite box.
Use another RFcoaxial cable to connect the antenna input jack of the unit to the output jack of the cable/satellite box.
e.g.)
satellite
dish
cable/satellite box
rear of this unit
RF OUT
coaxial cable RF coaxial cable
_Required cables and connecting methods differ depending on the cable/satellite box.
For more information, please contact your cable/satellite provider.
EN