JBM 54514 Manual De Instrucciones página 5

REF.54514
STEP 3: OPERATE THE EXTRACTOR
Manual Mode: Pull up the pump handle several
times to create a vacuum (maximum 25 times).
Pneumatic Mode: Connect the extractor to an
air compressor, adjust the pressure between
40-170 psi, and turn it on. Continuous pumping
is unnecessary.
Ensure the extension tubing touches the bo-
ttom of the reservoir for complete extraction.
SPECIAL NOTE: You can hang the unit from the
engine using the suspension bracket for ad-
ded convenience.
STEP 4: TRANSFER LIQUID
Completely drain the extension tubing before
removing it from the main tube.
Remove the main tube from the unit.
Pour the liquid into an appropriate container
(figure 4).
Remember to dispose of the extracted fluids
safely according to local regulations.
OTHER FLUIDS
Draining other fluids is easy with the extractor.
Choose the appropriate probe, insert it into
the fluid, and connect the main suction tube
to both the pump inlet and the probe. The
operation of the extractor is the same as des-
cribed above.
MAINTENANCE
PARTS LIST (EXPLODEDE VIEW)
1.Brake bleeding hose
2. Main tube Φ0.31x0.39 in / L: 39.3 in
3. Extension tube 1 Φ0.21x0.26 in / L: 39.3 in
4. Extension tube 2 Φ0.16x0.24 in / L: 39.3 in
5. Extension tube + wire Φ0.14x0.18 in / L: 39.3 in
6. Dust-proof sealing cover
7. Hose storage unit
8. Oil extractor tank
9. American interface
· 5 ·