Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Meaning of the LED indicators
On the headphones (Power button):
- Blue LED flashes rapidly: Searching for a signal
- Blue LED stays on continuously: Power on
- Blue LED flashes slowly: Low battery level
- Red LED lights up with headphones off (charging cable connected): Charging
- LED is off with headphones off (charging cable connected): Charging completed
On USB receiver:
- Red LED is flashing rapidly: Searching for a signal
- Red LED lights up: Headphones paired successfully
Pairing the headphones
1. Press and hold the Power button (D) for 3 to 5 seconds.
2. After beep, enter pairing mode.
3. When the USB receiver has a steady red light, it means the pairing has been successful.
Wired connection of the headphones
The headphones can be used with the included 3.5mm audio cable.
1. Insert the 3.5mm jack cable into the headphones.
2. Insert the other end into the device where you want to use it.
Switching between wireless and wired modes is done with minimal delay.
How to charge the internal battery
1. On the right earcup, carefully insert the USB-C connector of the charging cable into the
USB-C port and connect the other end of the cable to a free USB port on a working
computer or compatible wall charger.
2. The red LED on the power button (D) will illuminate, indicating that the headphones is
charging.
3. When charging is complete, the LED on the power button (D) will turn off. Charging is
complete in approximately 3 hours.
8
Publicidad
