Publicidad
Idiomas disponibles
Idiomas disponibles
Interface Box
Reset Button
LED
Vehicles without steering wheel controls
1. From the 3.5mm adapter, tie the Brown and Brown/White
wires together and tape up or use a connector.
2. Connect the 3.5mm adapter to the 3.5mm jack from the
vehicle harness.
3. Program the interface per the instructions, page 4.
2
CONNECTIONS
Connect interface harness
to aftermarket radio harness
Black - Ground
Yellow - Battery power
Red - Accessory power
Orange - Unlabeled
Purple/Black - Rear right speaker -
Blue/White - Amp turn-on (connect)
Blue/Pink - VSS/Speed-Sense
Green/Purple - Reverse signal
Light Green - Parking brake
Gray - Front right speaker +
Gray/Black - Front right speaker -
White - Front left speaker +
White/Black - Front left speaker -
Green - Rear left speaker +
Green/Black - Rear left speaker -
Purple - Rear right speaker +
Orange (labeled IFACE ILL) - Illumination *
* Only connect the Orange wire labeled IFACE ILL to the illumination wire!
The unlabeled Orange wire will only be used if one of the Orange wires
on the main harnesses are available on the factory side.
Vehicle
Connectors
Aftermarket Radio
(radio's features may vary)
Front
Rear View
Rear
AUX-IN
Sub
SWC
3.5mm Adapter (for radios with a wire for SWC)
Boss (with SWC wire): Key 1 (Gray) - Brown
Kenwood/JVC (with SWC wire): Blue/Yellow - Brown
XITE: SWC-2 - Brown
Universal Radio*:Key-A or SWC-1 - Brown
Key-B or SWC-2 - Brown/White
* After programming, assign SWC buttons within radio menu
Publicidad
