Publicidad
Idiomas disponibles
Idiomas disponibles
Built to Exceed
R M
2 6 0 4
Keep Working
USE AND CARE OF POWER TOOLS
• Do not force the tool. Use the appropriate elective tool for your work. With the right tool you can work better and more safely,
at the pace for which it has been designed.
Do not use any power tool whose switch is defective. An electric tool that cannot be turned on and off is dangerous and must be
repaired.
• Disconnect the plug from the power outlet before making any adjustment to the tool, changing accessories or storing the tool.
These preventive safety measures reduce the risk of accidental start-up of the tool.
• Keep the tools you use out of the reach of children. Do not allow a person unfamiliar with these instructions to use the tool.
Power tools are dangerous in the hands of an untrained person.
• Maintenance of power tools requires attention. Verify the alignment or the union of the moving parts, the absence of parts and
any other situation that could affect the operation of the tool.
• If the tool is damaged, have it repaired before use. Many accidents are due to lack of maintenance. Keep cutting tools clean
and sharp. Cutting tools in good condition and sharp are easier to handle and seize less.
• Use the power tool, accessories, voltage, etc. according to these instructions and as indicated for each type of tool.
• Always consider the working conditions and the work itself. Improper use of power tools can lead to dangerous situations.
5.5 SERVICE
• The service interventions in your power tool must be carried out by qualified persons who only use identical spare parts. In this
way, the safety of the power tool will be maintained.
6 SAFETY SPECIFIC RULES FOR HAMMER ROTARY AND IMPACT DRILLING
• To protect against the risk of electric shock, injury and fire when using a power tool, it is essential to take the following basic
safety precautions. Read and write down these instructions before using the machine.
• Check the voltage (voltage) indicated on the information plate.
• When using cable reels, unwind the reel cable entirely. Minimum conductor cross section: 1.0 mm2 •
• Make sure that you are well supported on the ladder and scaffold when drilling by free hand.
KEEP WORKiNG
07
Publicidad
