Generac G0071031 Hoja De Instrucciones página 2

Figure 2. Removing Customer Connection Panel
Cover (2013–2015 Units)
Installing the Breather Heater
400 Series Engines
1. See Figure 3. Wrap breather heater (A) around
breather hose, evenly spaced as shown, with lead
wires at the bottom. Wrap breather heater and
hose with silicone tape (provided) to secure heater.
A
Figure 3. Wrapping the Breather Hose (400 Series)
2. See Figure 4. Route lead wires beneath and
behind engine as shown.
Figure 4. Routing Heater Wires (400 Series)
Breather Heater Kit
A
B
3. Pass lead wires through harness grommet (B) in
engine divider panel. Secure all wires with plastic
wire ties at least 0.5 in (1 cm) away from fuel
hoses.
4. Proceed to
800 Series Engines
1. See Figure
breather hose, evenly spaced as shown, with lead
wires at the top. Wrap breather heater and hose
with silicone tape (provided) to secure heater.
002916
C
Figure 5. Breather Hose (800 Series)
2. Route lead wires between intake elbow (D) and
mixer (E), as shown.
3. Pass lead wires through harness grommet (F) in
engine divider panel.
4. Secure all wires with plastic wire ties at least 0.5 in
(1 cm) away from fuel hoses.
5. Proceed to
500/1000 Series Engines
002760
1. See Figure
elbow (H), and air filter (I).
I
Figure 6. Removing the Airbox Cover (500/1000
002763
Connecting Lead Wires.
5. Wrap breather heater (C) around
Connecting Lead Wires.
6. Remove airbox cover (G), intake
G
Series)
D
F
E
009528
H
002765
2