Publicidad
Idiomas disponibles
Idiomas disponibles
2. See
Figure
7. Remove three mounting screws
behind engine divider panel to disconnect snorkel
(J).
J
Figure 7. Removing the Snorkel (500/1000 Series)
3. See
Figure
8. Remove screws from airbox base
(K).
Figure 8. Removing the Airbox Screws (500/1000
4. See
Figure
9. Remove screws attaching mixer to
intake manifold (access screws behind divider
panel). Set airbox base and mixer (L) aside, with
wires still connected to mixer, to expose breather
hose (M).
L
M
Figure 9. Removing the Mixer (500/1000 Series)
Breather Heater Kit
K
Series)
NOTE: See
Figure
engines (2016–Present), the lower mixer screw is acces-
sible through a hole (N) in the engine divider panel.
Remove plastic cover from the hole and set aside for
reassembly.
N
009589
Figure 10. Access Hole in Divider Panel
5. See
Figure
breather hose, evenly spaced as shown, with lead
wires at the bottom. Wrap breather heater and
hose with silicone tape (provided) to secure heater.
009591
Figure 11. Wrapping the Breather Hose (500/1000
6. Pass lead wires through harness grommet (Q) in
the engine divider panel.
7. Secure all wires with plastic wire ties at least 0.5 in
(1 cm) away from fuel hoses.
8. Install mixer with air box base and snorkel.
9. Install intake elbow, air filter, and air box cover.
10. Proceed to
009590
10. For units with the 1000 Series
11. Wrap breather heater (P) around
Q
P
Series)
Connecting Lead
Wires.
009629
009639
3
Publicidad
