UFESA Final Cut Manual De Instrucciones página 20

INSTRUCTIONS FOR USE
CHARGING THE APPLIANCE
The shaver is very practical to carry and can be charged anywhere
with the USB cable (8). First, insert the plug on the end of the USB
cable (8) into the unit, and then connect the USB cable to the USB
interface. This device is suitable for 5V DC Max 1A charger, compu-
ter and other power interfaces. Note that when connected to the
power supply, the LED light bars (6) continuously illuminate until
fully charged. The shaver is fully charged in 2 hours. A fully charged
shaver can be used for 45 minutes, which means approximately 6
shaving sessions. The low battery indicator LED (6) starts flashing
and beeps when the appliance needs to be recharged. At any time
it is possible to see the percentage of battery level of the appliance
on its LCD screen (6).
HOW TO SHAVE
Do not press the shaver too hard against the skin.
1. Press the ON button (5) to turn on the shaver.
2. Move the shaving heads over the skin in gentle circular motions
to capture all the hair.
3. Move the shaver in the opposite direction to facial hair growth, or
shave in the same direction if your skin is sensitive.
4. If you want to trim your sideburns and mustache, replace the
head (4) with (7) and move it down with gentle pressure. After sha-
20