UFESA INSPIRE U5 DIGITAL Manual De Instrucciones página 20

BATTERY REMOVAL
PLEASE REMOVE THE BATTERY BEFORE DISCARDING IT.
The appliance must be disconnected from the supply
mains when removing the battery.
Make sure the battery pack is fully discharged.
Press the battery removal button and remove the battery from the product.
PLEASE ENSURE THE BATTERY IS DISPOSED OF SAFELY.
IMPORTANT WARNINGS
Prior to plugging in the product, check that your mains voltage is the same as the one
indicated on the product label. The mains connection cable must not be tangled or
wrapped around the product during use. Do not pull on the mains connection cable
in order to unplug it. Do not use, connect or disconnect the device to the mains with
your hands or feet wet. Proceed according to the conservation and cleaning section of
this manual for cleaning. Unplug the product immediately from the mains in the event
of any breakdown or damage and contact an authorized technical support service. In
order to prevent any risk of danger, do not open the device. Only qualified technical
personnel from the brand' s Official Technical support service may carry out repairs
or procedures on the device. Any incorrect use or improper handling of the product
shall render the warranty null and void. Only an authorized technical support service
center may carry out repairs on this product. This appliance is designed exclusively for
domestic use, in no case should be put in commercial or industrial use. In case of mi-
suse or tampering with the product, it will be out of warranty. Do not use the appliance
to vacuum liquids (water, etc), sharp objects (pins, pins, nails, glass, etc), incandescent
objects (matches, cigarettes). Never use the turbobrush to: Polish floors, suck (Liquids,
wet or damp dust, hot ash, burning objects, such as cigarettes, matches, sharp and
hard items, such us: razors, pins, thumbtacks, pieces of glass, etc), flour, cement, plas-
ter, printer or photocopier toner, etc.
B&B Trends, S.L. disclaims all liability for damages that may occur to people, animals
or objects, for the non-observance of these warnings.
MAIN UNIT ASSEMBLY
Install the battery pack into the appropriate slot of the main unit. It will "click" into pla-
ce. Insert the connector of the motorized floor head into the base of the extension tube
by clicking it into place. Attach the extension tube into the motorized power brush, it
will "click" into place. Connect the main unit with the extension tube, you will hear the
"click" when it is correctly assembled (Fig. 1)
Extension Tube: Use this for extended reach when using as an upright unit or for tho-
se hard-to-reach places.
20