Publicidad
Idiomas disponibles
Idiomas disponibles
REF.60047C
Modes of operation
Screwdriving
Select the screwdriving mode:
Set the torque level.
Place the point of the bit into the screw head.
Press the trigger.
Note: Start the tool at a low speed and then
increase the speed gradually.
Drilling
Select the drilling mode: .
Place the drill into the chuck.
Press the trigger.
Note: When drilling in metal, to prevent the bit
from slipping it is advised to make an indenta-
tion with a center-punch and a hammer at the
point to be drilled.
Hammer-drilling
Select the hammer-drilling mode: .
Press the trigger.
LED working light
The LED light is useful in poor lighting condi-
tions to illuminate the work area.
The LED light will turn on as soon as you press
the trigger.
Turning off the tool
To switch off the machine, release the trigger.
Security lock
When you finish using the tool, set the direction
selector to the neutral position.
By doing this you will lock the trigger and will
avoid accidental starting of the tool.
MAINTENANCE
Repairs must be performed by a qualified ex-
pert using only identical replacement parts.
This will ensure that the safety of the tool is
maintained.
Disconnect the battery pack before changing
accessories.
Recharge the battery at least once a year to
maintain its charging capacity.
CLEANING
Unplug the battery from the tool and the char-
ger from the wall outlet before cleaning.
Clean the tool with a clean cloth or clean with
compressed air at low pressure.
Do not use any cleaner or detergent they can
damage the plastic parts of the tool.
Ensure that no water enters the tool.
We recommend cleaning the tool directly after
each use.
DISPOSAL
This device uses electronic com-
ponents so they should not be
deposited with household
garbage.
Dispose of the tool in a recycling
center.
· 9 ·
Publicidad
