BOLERO Y829 Manual De Instrucciones página 11

Telephone Helpline: 0845 146 2887 (United Kingdom)
Fitting the Cover
WARNING: Attempting to fit the covers to the Gazebo in windy conditions may be
hazardous and could result in injury and or damage to the product.
The Gazebo cover comes in 5 parts; the roof and the four sides.
Step 1 - Fit the Panels
Note: The front panel has a zip.
BOLERO recommend that the front panel is hung in the same position as connecting
piece B and connecting piece C.
Hang the panel to the outside of the frame.
1.
To secure the panel:
2.
Slot the end of a bobble-tie through each eyelet. Loop the elastic around the frame and back over
i.
the bobble.
Slot a plastic ring over the frame and through each of the eyelets. Snap the ring shut.
ii.
Push a ground hook through each of the holes in the bottom of the panel.
iii.
Repeat for the remaining panels.
Step 2 - Open the Front Panel
Completely undo the zip.
1.
Remove the panel to open the front of the gazebo.
2.
Step 3- Fit the Roof Cover
Pull the cover over the top of the frame to create the peak.
1.
To secure the roof cover to the frame:
2.
Pull down the eight corner flaps and hook the ends to
i.
the lowest hole possible in the leg [Fig.1].
Slot the end of a bobble-tie through each eyelet inside
ii.
the roof cover. Loop the elastic around the frame and back over the bobble [Fig. 2].
Tie a guide rope to each corner flap and secure to the ground with a ground hook.
3.
Step 4 - Insert the Roof Support
The roof support lifts the roof from the frame [Fig. 3].
Place the end cap onto the top of the centre piece.
1.
Screw the threaded bar up through the central connecting
2.
piece, ensuring the end of the bar slots in to the end cap.
Use the Screw arm if required.
Note: The end cap is necessary to prevent damage
to the roof cover.
Repeat for the second roof support.
3.
Fig. 1
Fig. 2
End Cap
Fig. 3
Centre Piece
UK
4