Silver Style FS-M01 Manual De Instrucciones página 39

the lowest "MAX" level. Do not exceed this lower "MAX" level when frothing
milk, otherwise the frothed milk could overflow and enter the body of the
appliance, damaging the internal circuit.
- Press the ON/OFF switch (4) to switch on the milk frother.
- Press FUNCTION (4) to select one of the following functions :
➢
heating it. The light flashes for a few seconds, then stays on without
flashing and the milk frother starts to work.
➢
a dense foam. The light flashes for a few seconds, then stays on
without flashing and the milk frother starts to work.
➢
milk to a thick foam. The light flashes for a few seconds, then stays
on without flashing and the milk frother starts to work.
➢
frothing it. The light flashes for a few seconds, then stays on without
flashing and the milk frother starts to work. The whisk turns slowly
and does not froth the milk.
- You can stop the machine at any time simply by pressing the ON/OFF
button (4).
To prevent the milk from sticking to the sides of the container,
rinse the container immediately with cold water after each use.
CLEANING AND MAINTENANCE
Before cleaning the milk frother, make sure that the appliance is switched
off and unplugged and that it has cooled down completely.
Do not immerse the base in water. Avoid splashing water or other liquids
onto the base of the container. Do not use abrasive products, solvents or
strong detergents to clean the exterior and base of the product, but wipe
them with a cloth dampened in lukewarm water. To clean the inside of the
appliance, wait until it has cooled down and then rinse it with cold water to
remove any residue or impurities.
- Press the function button once to froth cold milk without
- Press the function button twice to heat and froth the milk to
- Press the function button three times to heat and froth the
- Press the function button four times to heat the milk without