Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
1
Attach the table legs
Place the tabletop (A) up-side down on a flat, solid surface.
□
Attach a table leg (C) to the tabletop (A) using the bolts (AA)
□
and washers (BB) as shown in the diagram.
Guide the bolts (AA) through the holes in the tabletop (A)
□
corner bracket and into the pre-drilled hole in the table leg.
Hand tighten three to four turns only. (Do not tighten
□
completely.
Repeat for the other three legs.
□
II (Preassembled)
C
CC
AA
BB
3
Tighten the nuts to the bolts
Use the hex bolt driver (GG) and hex wrench (FF) to tighten
□
all nuts (DD) and bolts (AA).
Repeat until all bolts (AA) are tight. (Do not over tighten.
□
Over tightening may strip bolts.)
Cover all nuts (DD) and bolts (AA) with covers (EE).
□
A
2
Attach the leg connector bracket
Attach a leg (C) to the leg connector bracket (B) by carefully
□
guiding the bolts (AA) already in place on the table leg (C)
connector bracket ( B).
Add a washer (BB) and a nut (DD) to the end of each bolt.
□
Hand tighten three to four turns only. (Do not tighten
□
completely.)
Repeat for the other three legs.
□
5
Please contact 1-855-HD-HAMPTON for further assistance.
EE
DD
BB
B
HAMPTONBAY.COM
C
Publicidad
