Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
5
Attaching the quick connector
to the receiving block
Push the quick connector (H) firmly upward and
attach it to the receiving block (1). Pull down
moderately to ensure the connection has been
made.
1
H
6
Making the water supply
connections
NOTE: The hot side inlet tube is indicated by a label. If the
label is not present, the hot supply tube is the longer of the
two inlet tubes.
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
1
3
NOTE: Before tightening the faucet connector to the water
supply, apply a second wrench to the supply tube fitting.
This will prevent the supply tube from moving or twisting
when tightening the faucet connector. Do not overtighten.
20
2
Publicidad
