Kobalt 19003 Instrucciones De Montaje página 10

ASSEMBLY INSTRUCTIONS
8. Determine the location for the cabinet
bracket (K). If you plan to hang the unit onto
drywall, please follow below steps. Feed
ST4.8 x 57 mm pan head tapping screws
(KK) through 5 x 15 x 1.2 mm washers (LL)
and cabinet bracket (K). Drill the ST4.8 x 57
mm pan head tapping screws (KK) to the
wood stud.
Hardware Used
ST4.8 x 57 mm Pan
KK
head tapping screw
5 x 15 x 1.2 mm
LL
Washer
OPTIONAL
If you plan to hang the unit onto cement wall,
please follow below steps. Drill 4 holes (with
the diameter of about 8.5 mm) in the cement
wall. Insert D8 x 50.8 mm expansion
tubes(JJ) in the drilled holes. Feed ST4.8 x
57 mm pan head tapping screws (KK)
through 5 x 15 x 1.2 mm washers (LL) and
cabinet bracket (K). Screw ST4.8 x 57 mm
pan head tapping screws (KK) to the D8 x
50.8 mm expansion tubes (JJ) in the cement
wall.
Hardware Used
D8 x 50.8 mm Expansion tube
JJ
ST4.8 x 57 mm Pan
KK
head tapping screw
5 x 15 x 1.2 mm
LL
Washer
Note: Ensure the cabinet bracket (K) is installed horizontally, or the two doors will probably not be
properly aligned after step 9.
8
K
x 2
x 2
K
Cement wall
x 4
x 4
x 4
10
Stud wall
KK
Stud wall
JJ
Cement wall
LL