NightStick XPR-5592 Manual De Instrucciones

Instruction Manual
XPR-5592
US Patent 10,879,519 & 11,450,934
THE XPR-5592 IS APPROVED FOR USE
Bayco Products, Inc.
640 S. Sanden Blvd., Wylie, TX 75098
FLOODLIGHT FOR USE IN HAZARDOUS LOCATIONS
For use with Bayco Li-ion Battery Pack 5592-BATT only
E 467756
CLASS I DIV 1 GRPS A-D T4
ID 4003544
CLASS II & III DIV1 GRPS E-G T135°C
ELECTRICAL SAFETY
CLASS I ZONE 0 GROUP IIC T4 Ga
INTRINSICALLY SAFE
II 1G Ex ia op is IIC T4 Ga
SECURITE INTRINSEQUE
Ex ia op is IIC T4 Ga
DEMKO 19 ATEX 2169
UL22UKEX2429
2575
IECEx UL 19.0013
5592-BATT
0359
3.7V/Cell Li-ion
ATENÇÃO – UTILIZAR SOMENTE BATERIAS BATT-5592.
ATENÇÃO – NÃO SUBSTITUIR A BATERIA QUANDO UMA ATMOSFERA EXPLOSIVA
PUDER ESTAR PRESENTE.
ATENÇÃO – NÃO RECARREGUE A BATERIA EM ÁREAS CLASSIFICADAS.
WARNINGS - INTRINSICALLY SAFE
• WARNING: Use only the approved Nightstick 5592-BATT Lithium-ion rechargeable battery pack or the
approved non-rechargeable batteries listed below.
• WARNING: To prevent ignition of a hazardous atmosphere, do not open the battery compartment or
attempt to exchange any of the supplied battery packs while in the hazardous environment. This task
must ONLY be performed in an area known to be non-hazardous.
• WARNING: To prevent ignition of a hazardous atmosphere, the approved Nightstick 5592-BATT
Lithium-ion rechargeable battery pack must only be charged in an area known to be non-hazardous.
• WARNING: To reduce the risk of explosion, do not mix new non-rechargeable batteries with used
non-rechargeable batteries, or mix non-rechargeable batteries from different manufacturers.
• WARNING: Substitution of components may impair intrinsic safety.
SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY
location where the light is to be used.
CAUTION
• Charger Input is 12 VDC Max
• Rechargeable Lithium-ion batteries must be used and charged properly. Improper use can result in
• Do not leave the battery in direct sunlight or use or store the battery inside cars in hot weather.
• Do not expose the battery to water or salt water, or allow the battery to get wet.
• Do not store the battery with metallic objects that may cause a short circuit.
• Immediately discontinue use of the battery if the battery emits an unusual smell, feels hot, changes
color, changes shape or appears abnormal in any way.
• Keep out of the reach of children.
INITIAL USE
Warning: To prevent ignition of a hazardous atmosphere, do not attempt to charge this product
in the hazardous environment. This task must ONLY be performed in an area known to be non-
hazardous.
months. The maximum charge time required is approximately 6-7 hours.
DAILY USE
WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, DO NOT ATTEMPT TO
CHARGE THIS PRODUCT IN THE HAZARDOUS ENVIRONMENT. THIS TASK MUST ONLY BE
PERFORMED IN AN AREA KNOWN TO BE NON-HAZARDOUS.
• Use only the supplied Nightstick AC or DC adapter. For best performance, charge the XPR-5592
when the light starts to dim.
• Connect the AC or DC adapter into the bottom of the light.
• The total time to full charge the XPR-5592 varies depending on the remaining charge in the battery
pack.
• For the light to be waterproof, the charging port must be well covered by the screw cap. (Image 1)
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
OPERATION
CAUTION: BECAUSE THE XPR-5592 HAS A MAGNETIC BASE, IT IS LIKELY THAT IT WILL BE
PLACED IN AN ELEVATED POSITION ABOVE THE GROUND. THEREFORE CAUTION SHOULD
BE USED TO BE CERTAIN THAT THE MAGNET IS SECURELY ATTACHED TO THE METAL
SURFACE BEFORE RELEASING THE LIGHT. IT IS ALSO ADVISED THAT EXTRA CARE BE
TAKEN WHEN ADJUSTING OR MOVING THE CORD SO THAT THE WORK LIGHT DOES NOT
COME LOOSE AND FALL TO THE GROUND.
The XPR-5592 has a single three-position toggle switch with black boot. Operation as seen from the
back of the light:
• Center position:
• Right position:
• Left position:
XPR-5592
SETTING UP THE WORK LIGHT ON A TRIPOD
Opening the tripod leg set:
Fully unfold the tripod leg set and slide the center collar down until it locks into place.
Ex ia op is IIC T4 Ga
(-20ºC Tamb +40ºC)
WARNING: Do NOT attempt to use the tripod leg set unless the legs are fully extended and locked
NCC 21.0075
into place. This is the ONLY position that the leg set can be used in.
Closing the tripod leg set:
Press the release button on the side of the center collar and then raise the center collar up until the
tripod leg set is fully retracted.
Adjusting the column sections:
22-AV4BO-0221X
The tripod has two adjustable sections of the column that can be used to customize the working
height of the work light. Each section is locked into place by means of a cam lock lever. (Image 2) To adjust
the height of either section, release the cam lock lever for that section, extend the column to the desired
length and the re-lock the cam lock lever.
Removing the light from the tripod:
The product is designed so that the light can be removed from the tripod. To remove the light, grasp
the lights handle with one hand, and grasp the top of the tripod stand with the other hand a pull the magnet
apart from the mounting plate.
Installing the light onto the tripod:
CAUTION: Before installing the light on to the tripod, be certain that the leg set is fully extended
and locked in place and that both of the two column cam lock levers are securely locked.
To install the light head on to the tripod, simply line up the light heads magnetic base with the tripods
mounting plate (Image 3) allowing the magnet to secure itself to mounting plate. Be sure place the light
head directly onto the center of the mounting plate so that the light head is securely mounted.
WARRANTY
1 YEAR WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship and
materials to the original purchaser for 1 year from the date of purchase, and includes the LEDs,
housing, lenses, electronics, switches, rechargeable batteries and chargers. Bulbs (other than
LEDs) are covered for 90 days from the date of purchase.
We will repair or replace this product should we determine it to be defective. This is the
particular purpose.
For a complete copy of the warranty, go to www.nightstick.com/nightstick-product-support/
warranties. Retain your receipt for proof of purchase.
INS-XPR-5592-DL-23
Off
High-brightness
Low-brightness
Image 1 Image 2 Image 3
02-22-2023